|
|
|
 FIRST, in itself, will not make you an engineer. - RogerR [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| FIRST, in itself, will not make you an engineer. - RogerR [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Turning Radius
Hello.
Our team has its turning wheels basically on a turn-table, so they both turn at the same time. Is there any formula I can use to determine turning radius, when I know how much I have 'turned' the turn-table off center-straight? |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| turning a turntable | caffino54 | Technical Discussion | 2 | 07-02-2009 01:45 |
| turning it all in | Pneumaticsman | SolidWorks | 0 | 16-01-2008 19:34 |
| Turning 18... | Astronouth7303 | Chit-Chat | 16 | 22-05-2006 09:29 |
| Turning Trouble! | Cadetdan | General Forum | 18 | 05-03-2005 08:55 |
| Recalculate Gizmo Radius | iamnafets | 3D Animation and Competition | 0 | 23-02-2004 16:17 |
Threaded Mode