|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
|
|||
|
|||
|
Re: Can any one help us with programing the encoder to control the motor by ticks?
Motors alone cannot do this. If you add a pot or an encoder, then you have a shot. Another way to go about this is with limit switches.
It is reasonable to think of a servo as a motor, a pot, and a loop that quickly adjusts the motor speed based on whether the pot is too low, too high, or just right. If you get a pot or encoder hooked up, try making a periodic task to read the pot and set the motor. Greg McKaskle |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| can we control the amount of air to control the speed of the cylinder? | Team2339 | Pneumatics | 22 | 11-02-2009 15:33 |
| [FTC]: [FTC]: Can any one explain to me just how powerful the servos are? | sullivan_owns | FIRST Tech Challenge | 19 | 02-12-2008 16:06 |
| programing the vex optical shaft encoder | youngWilliam14 | Programming | 10 | 11-11-2007 16:16 |
| can anyone please tell mw where or with what can i lear programing in C | techsage | Programming | 7 | 23-08-2005 00:25 |
| Has any one stuck a drill motor in the FP trans? | Lotownvw | Motors | 15 | 21-04-2003 23:57 |