|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
|
||||
|
||||
|
Re: Driver Station Digital Input
Jeremy,
Lucky for you that this input is somewhat fault tolerant. Use an ohmmeter to determine the pin arrangement on your switch. Connect one pole to +5, the other pole to ground and the common to the signal pin. Mike |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| drivers station digital input trouble | finman | Electrical | 9 | 16-02-2009 08:06 |
| Driver Station Input | SwampDogs | NI LabVIEW | 3 | 27-01-2009 11:33 |
| driver station digital outputs | DustinB_3 | FRC Control System | 0 | 24-01-2009 11:29 |
| Flashing Driver Station Digital Input | MacGyver1718 | FRC Control System | 3 | 15-01-2009 19:22 |
| Interrupt on driver station digital input | Nameless | Programming | 9 | 04-12-2008 16:55 |