Break Out Board??? - Chief Delphi

My wife is in advertising, and uses a scary amount of math. They have to know how to target you and beat down your defenses, so that you buy that hamburger while driving that car while wearing those designer jeans to your favorite store. - Not2B [more]

		Chief Delphi > Technical > Control System > FRC Control System
Break Out Board???

Thread Tools

Rate Thread

Display Modes

10-02-2009, 07:39

Betty_Krocker Betty_Krocker is offline

Fabricator/Hacker/Comic Relief

AKA: Michael

FRC #2028 (Phantom Robotics)

Team Role: Mechanical

Join Date: Jan 2008

Rookie Year: 2007

Location: Hampton, VA

Posts: 105

Betty_Krocker is an unknown quantity at this point

Send a message via Yahoo to Betty_Krocker

Break Out Board???

I haven't been able to find a set answer, so I am asking the audience...

If we are using Pneumatics, do we HAVE to use the Break Out Board, or can we go with a spike which we have been doing since the dawn of FIRST? Our programmers have the break out board and would love if we can use spikes because they have the program for it already...

__________________
"Measure once, cut twice... wait... what?"

"Two things needed to build a robot.. WD40 for the things that don't move but should, and Duct tape for the things that move but shouldn't"

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Figure out what's wrong with the IR board	sparrowkc	Electrical	5	17-02-2008 12:29
spring break	thatphotochick	Chit-Chat	6	29-03-2006 17:41
Need a little help with how to break out of the box	amateurrobotguy	Programming	6	16-01-2006 12:56
Perf Board = BS2-IC Carrier Board?	indieFan	Electrical	2	16-09-2004 08:28
Before I break anything...	Dmitri	Motors	7	10-02-2004 20:36

All times are GMT -5. The time now is 17:40.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.