|
|
|
 Freshman: "Why did it break?"
Another Freshman: "Because we don't know what we're doing!"
Veteran Student: "This is why we can't have nice things." - MechEng83 [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Freshman: "Why did it break?"
Another Freshman: "Because we don't know what we're doing!"
Veteran Student: "This is why we can't have nice things." - MechEng83 [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
10-02-2009, 08:08
|
|||
|
|||
|
Re: Doesn't execute teleop execute case
As mentioned, your encoders aren't hooked up. Also, you have a start communications in the Vision VI.
I don't see anything that would make Begin run more than once. Put a breakpoint on something like an open node in it. Right click and set breakpoint. If you hit the breakpoint more than once, the stack crawl ring at the top of the window will show who is calling. I think you'll find that there is only one call. Sorry I couldn't be more help. Greg McKaskle 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Can't get program to execute | Thxe | C/C++ | 3 | 09-02-2009 08:33 |
| Telling Labview which loop to execute first | professorX | NI LabVIEW | 5 | 02-02-2009 15:15 |
| execute.h | magical hands | Programming | 2 | 10-03-2007 21:02 |
| EasyC: Execute code before autonomous | Greg Marra | Programming | 7 | 07-01-2007 21:30 |
| How I can execute Javascript into Perl? | TomS | Programming | 3 | 22-08-2006 16:35 |
Threaded Mode