Break Out Board??? - Chief Delphi

"Professionalism at all times... even when you're playing an epic prank on your friends." - JVN [more]

		Chief Delphi > Technical > Control System > FRC Control System
Break Out Board???

Thread Tools

Rate Thread

Display Modes

10-02-2009, 08:48

Betty_Krocker Betty_Krocker is offline

Fabricator/Hacker/Comic Relief

AKA: Michael

FRC #2028 (Phantom Robotics)

Team Role: Mechanical

Join Date: Jan 2008

Rookie Year: 2007

Location: Hampton, VA

Posts: 105

Betty_Krocker is an unknown quantity at this point

Send a message via Yahoo to Betty_Krocker

Re: Break Out Board???

Alright thanx a lot because that makes our programmers job easier...

__________________
"Measure once, cut twice... wait... what?"

"Two things needed to build a robot.. WD40 for the things that don't move but should, and Duct tape for the things that move but shouldn't"

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Figure out what's wrong with the IR board	sparrowkc	Electrical	5	17-02-2008 12:29
spring break	thatphotochick	Chit-Chat	6	29-03-2006 17:41
Need a little help with how to break out of the box	amateurrobotguy	Programming	6	16-01-2006 12:56
Perf Board = BS2-IC Carrier Board?	indieFan	Electrical	2	16-09-2004 08:28
Before I break anything...	Dmitri	Motors	7	10-02-2004 20:36

All times are GMT -5. The time now is 17:40.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.