Driver Station Digital Outputs

Lafleur · #1 10-02-2009, 10:35

Anyone know how much current the DS outputs can sink or source??

tom lafleur
mentor team 812

Joe Ross · #2 10-02-2009, 10:48

See section 3.1.6.2 of the control system manual.

Alan Anderson · #3 10-02-2009, 10:50

See http://www.usfirst.org/frccontrolsystem and Chapter 3 Component Data Sheets of the Control System Manual.

Quote:

Originally Posted by 3.1.6.2 Driver Station Digital Outputs:

The DS digital output pins are driven directly by 5V transceiver (SN74LVC4245A device). Be sure to use caution as each pin can source/sink more than 40mA. It is possible to damage the device if too much current is driven on a single pin or the total current supplied by the device on all pins is excessive. Best practice should be to use a limiting resistor to prevent external loads from drawing excessive current, especially for LEDs, be sure to use a series resistor to limit the current.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Driver Station Digital Input	Lord_Jeremy	FRC Control System	2	09-02-2009 23:06
Digital Outputs on the Driver Station with C/C++	Bongle	C/C++	6	26-01-2009 15:45
driver station digital outputs	DustinB_3	FRC Control System	0	24-01-2009 11:29
Using driver station digital inputs	Japper	FRC Control System	6	19-01-2009 20:01
Interrupt on driver station digital input	Nameless	Programming	9	04-12-2008 16:55