|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools | Rate Thread | Display Modes |
|
#16
|
|||
|
|||
|
Re: Festo Solenoid Doesn't Work
Just to clarify, negative goes into 1, and the positive into 3?
|
|
#17
|
||||
|
||||
|
Re: Festo Solenoid Doesn't Work
I don't remember what the polarity is, but I do remember pin 1 is correct as shown on the connection diagram from festo. We just had to move the wire from pin 2 to pin three
Last edited by camtunkpa : 11-02-2009 at 16:48. |
|
#18
|
|||
|
|||
|
Re: Festo Solenoid Doesn't Work
My Festo would not work so i just switched to a SMC single solenoid and it works fine. I am going to change the wiring on the festo to see it that was the problem.
|
|
#19
|
|||
|
|||
|
Re: Festo Solenoid Doesn't Work
Team 2521 can also confirm that switching to 1 & 3 worked. One of them didn't, but we assume that that's because it was DOA.
|
|
#20
|
||||
|
||||
|
Re: Festo Solenoid Doesn't Work
our festo valves wouldnt work at all... we gave up and are using last years and now they wont work either
|
|
#21
|
|||
|
|||
|
Re: Festo Solenoid Doesn't Work
Are you getting any sort of LED response on the breakout or festo itself? Also, make sure that you're breakout is plugged into cRIO module 8 in NI 9472 or it won't work. If you have any more questions feel free to PM me.
|
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Festo Single solenoid | JP_1163 | Pneumatics | 4 | 24-02-2006 15:07 |
| Festo solenoid wiring? | computhief263 | Pneumatics | 1 | 15-02-2004 12:25 |
| festo solenoid | maxgebhardt | Pneumatics | 19 | 21-01-2004 23:06 |
| Festo valve.... why wont it work? | CHSguard72 | Pneumatics | 3 | 08-02-2003 19:07 |
| sensor doesn't work | PBoss | Programming | 7 | 29-01-2003 18:39 |