|
|
|
 That inspector needs their hard drive wiped and the common sense upgraded from version dingbat 1.0. - Andy Baker [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| That inspector needs their hard drive wiped and the common sense upgraded from version dingbat 1.0. - Andy Baker [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
10-02-2009, 23:30
|
||||
|
||||
|
Re: Labview motor control
Sean,
You are opening the Jaguar for PWM1 and PWM2 twice. Should be once... When the trigger is pressed, you are controlling the Jaguars via the tank drive VI and the button control both. This is the jerkiness you see. If I understand your intent, I think that you want to move the tank drive VI into the FALSE block of your button controlled case statement. Regards, Mike |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| C and LabView version control with Git | Nibbles | NI LabVIEW | 31 | 17-01-2010 19:22 |
| Tracking Servo motor with drive motor in Labview | mbone206 | Technical Discussion | 5 | 28-01-2009 17:32 |
| 2009 Control System LabVIEW Tips and Pitfalls | Travis Hoffman | NI LabVIEW | 3 | 22-12-2008 11:25 |
| LabVIEW Training and new control system demonstration 10/17-10/19 in Frazier Park, CA | Joe Ross | NI LabVIEW | 0 | 25-09-2008 13:25 |
| Labview Revision Control | Joe Ross | National Instruments LabVIEW and Data Acquisition | 2 | 11-05-2008 17:28 |
Threaded Mode