|
|
|
 Then as soon as we get the kit loaded into the back of my truck, we ferociously rip it open screaming "How many CIMs!?" - sanddrag [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Then as soon as we get the kit loaded into the back of my truck, we ferociously rip it open screaming "How many CIMs!?" - sanddrag [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
Re: Full solenoid controll off of one joystick button?
Here's a VI that I puzzled out over a few days - it takes a lot longer when you're somewhat new to a language. I'm sure there are more efficient ways, but this works.
The single input is a boolean - it could be from a joystick button or anything else - and the output toggles when the input changes from zero to one. btw its meant to be used as a subVI. -jonathan 
|
|
#2
11-02-2009, 02:06
|
|||
|
|||
|
Re: Full solenoid controll off of one joystick button?
Wow, thank you, that is the exact thing that I was trying to figure out how to do. I will test this out tomorrow
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| joystick button | furiousgeorge | Programming | 5 | 07-02-2009 15:57 |
| How do I program a relay to turn on and off by pressing a button on the joystick? | eweathers | NI LabVIEW | 4 | 28-01-2009 22:34 |
| Programming a joystick button... | programmr | Programming | 2 | 05-01-2009 16:13 |
| More than one joystick from one port | Jmoo | Programming | 3 | 26-06-2003 18:01 |
| Two Pneumatics off one Double-Solenoid Valve | GrahamS314 | Pneumatics | 5 | 24-02-2003 23:49 |
Hybrid Mode
