|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
|
|||
|
|||
|
Re: Is it possible?
Yep. To elaborate on what Eric is saying, instead of opening two motors, you can probably simplify by opening a Robot Drive. Then inside the loop scale the X setting as if it were a joystick X axis (-1 to 1). Scale the Y from the servo similarly, and wire those to the Robot Drive VI to control the motors.
Greg McKaskle |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Possible Problem!? | Gabriel Mendez | General Forum | 20 | 06-01-2008 01:30 |
| Possible DC Regional | spatel | General Forum | 3 | 26-04-2007 19:03 |
| Is it possible... | BLAZE | Pneumatics | 11 | 04-04-2005 22:02 |
| Is it possible... | Jon K. | CD Forum Support | 4 | 26-08-2002 00:01 |
| Possible Openings | archiver | 2001 | 0 | 24-06-2002 03:33 |