|
|
|
 First of all, please remember that while we often focus on winning the Chairman's Award, that it is the effort to win that matters. No one "loses" RCA... if you've worked your butt off all year in the spirit of the award, then you've already won before you even get to the regional. - dtengineering [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
11-02-2009, 17:32
|
|||
|
|||
|
Re: Last Minute Pneumatics Programming Help
The pressure switch is hooked up. I don't have any pressure switch VI's in LabView, aside from the terminal that IS wired correctly in LabView. Sorry I didn't specify. Yes, I've assigned the correct value to the pressure switch DIO.
As a side note, we've connected the compressor to the battery briefly for the purposes of testing the compressor, and it works. Last edited by T3HN3RDY1 : 11-02-2009 at 17:36. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Last minute autonomous programming! | ZP8892 | Programming | 7 | 16-03-2008 22:43 |
| Last Minute Programmer - Need Help! | burkey_turkey | Programming | 11 | 04-03-2008 23:16 |
| pneumatics programming help | diaperrash89 | Programming | 0 | 14-02-2008 17:19 |
| Last Minute Programming Failures | robobrain0101 | Programming | 3 | 11-02-2007 14:30 |
| Last-Minute changes? | Iain McLeod | General Forum | 9 | 09-04-2003 02:51 |
Threaded Mode