|
|
|
 I HAVE IT PROGRAMMED!!!! Ive just been forbidden from testing it... they think ill make the bot explode. >.> - Got_POSTWAFFLE? [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I HAVE IT PROGRAMMED!!!! Ive just been forbidden from testing it... they think ill make the bot explode. >.> - Got_POSTWAFFLE? [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Solenoids not working (programming)
 I am currently attempting to get solenoids to work to control a pneumatic ram. However, when I run code, I get this error. I have my solenoid module connected in module 6. I know 8 is the default, but it doesn't light up in 8 .... The only thing that runs in my code is the compressor. The joysticks don't even give an input ... |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| jaguar not working | Bwood16 | Motors | 12 | 13-02-2009 13:22 |
| Remembering not working | EricH | CD Forum Support | 9 | 21-07-2008 07:43 |
| p2 not working? | Lone_Wolf92c | Programming | 5 | 22-02-2008 08:49 |
| IR Board Not Working (But NOT Fried) | itsme | Electrical | 2 | 18-02-2008 06:11 |
| have a question to ask about Double Solenoids to one spike programming | davelu | Programming | 3 | 22-02-2005 09:52 |
Threaded Mode