|
|
|
 Anyone who makes a minibot that poots out another minibot that blows the wall apart deserves to have it displayed in the Smithsonian. - Koko Ed [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Anyone who makes a minibot that poots out another minibot that blows the wall apart deserves to have it displayed in the Smithsonian. - Koko Ed [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#10
11-02-2009, 21:11
|
||||
|
||||
|
Re: [FTC]: Any teams using dead axles for arms?
the problem we were having was that the clamps at the top gear of our arm were failing. we have a medium and small gear(i dont know the teeth number) on one axle, that sits between the big gear that is attached to the axle on the arm and a small gear that is on the motor. The center axle and gear setup does not slip or anything, it is always just the clamps that attach the big gear to the axle. We ended up figuring a way to get a clamp on each side of the big gear and putting a screw through the gear and two clamps. That seemed to fix our problem but it was an "on the spot" thing and we need to make it final or use something different such as the dead axle idea.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [FTC]: Tips page on using FTC Encoders with LabVIEW | PhilBot | FIRST Tech Challenge | 7 | 27-01-2009 14:00 |
| Voltage-to-resistance converter for using any joysticks | ConKbot of Doom | Control System | 14 | 15-07-2006 12:13 |
| Live vs. Dead axles | sanddrag | Technical Discussion | 28 | 03-05-2006 20:49 |
| have any teams had any luck approaching local malls for spaces to practice? | amos229 | General Forum | 28 | 07-01-2006 10:30 |
| for teams with arms | sburro | General Forum | 14 | 18-05-2005 22:09 |
Threaded Mode