Speed control - Chief Delphi

11-02-2009, 21:39

Drake Hunter Drake Hunter is offline

Fighting Rednecks

FRC #2883 (F.R.E.D)

Team Role: Programmer

Join Date: Feb 2009

Rookie Year: 2008

Location: Warroad, MN

Posts: 15

Drake Hunter is an unknown quantity at this point

Speed control

I was wondering how i would go about progamming a motor to run slower with the joystick axis in labview...thanks

11-02-2009, 23:08

Mike Betts Mike Betts is offline

Electrical Engineer

no team

Team Role: Engineer

Join Date: Dec 2001

Rookie Year: 1995

Location: Homosassa, FL

Posts: 1,442

Mike Betts has a reputation beyond repute

Re: Speed control

http://thinktank.wpi.edu/article/140

__________________
Mike Betts

Alumnus, Team 3518, Panthrobots, 2011
Alumnus, Team 177, Bobcat Robotics, 1995 - 2010
LRI, Connecticut Regional, 2007-2010
LRI, WPI Regional, 2009 - 2010
RI, South Florida Regional, 2012 - 2013

As easy as 355/113...

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Speed Control	dr_jack3l	National Instruments LabVIEW and Data Acquisition	3	14-02-2009 14:35
can we control the amount of air to control the speed of the cylinder?	Team2339	Pneumatics	22	11-02-2009 15:33
Drive Control, Wheel Speed Calibration, and Rapid Speed Changes	7-11number1	Programming	3	23-01-2008 20:36
switch speed control	wayne 05	Programming	6	01-10-2003 09:35
speed control	punarhero	Technical Discussion	11	24-01-2002 18:03

All times are GMT -5. The time now is 21:49.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.