Jaguar/Victor Not Getting Signal on Default Code

[excel2474]

We are having the same problem as discribed in this post.

Originally Posted by Alan Anderson

There is a trio of pins at the end of the Analog Breakout opposite the power connection. You need to install a jumper between the two pins nearest the edge of the board in order to connect the battery sense circuit to the required analog input pin.



Which "lights" are solid green? There is only one Robot Status Light, and it is only solid when the robot is running code and enabled. Otherwise it is flashing.

If the analog breakout is not on the crio, will this cause the problem. We don't have the analog breakout on and we don't have the jumper on. What is the jumper, what does it look like, and can you give me very detailed instructions of how to wire it. thanks