jaguar not working

[TheDarkDuck]

I'm looking for an answer in labview if at all possible, not C++
everyone on our team is new to labview so we are stuck on a problem that anyone who is familiar with the system could answer with their eyes closed.

[utlinebacker]

I just noticed something...

The "tom-tech" link mentioned above is not the latest/greatest Getting Started Guide. Please make sure you download it (and recommend downloading it) from the source: http://www.luminarymicro.com/jaguar. (I think another unauthorized link is floating around on the forum somewhere - would appreciate any help notifying me if you stumble across it)

In the meantime, I am trying to contact the folks hosting our doc and take it down/redirect to our site in order to avoid confusion.

Regards,
Scott

[dyanoshak]

Originally Posted by TheDarkDuck

I'm looking for an answer in labview if at all possible, not C++
everyone on our team is new to labview so we are stuck on a problem that anyone who is familiar with the system could answer with their eyes closed.

I've attached an image of some LabView code that might help. Sounds like you're wanting to saturate your inputs and LabView has a nifty block that will do it for you.

Note: This code isn't complete, I'm only showing the connections dealing with saturation, not the motor references, etc.