|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
|
||||
|
||||
|
Re: pic: Dawgma 'Alice' Isometric
Do you have any protection for that front roller? In Aim High we had an 18" opening on our front with a guarded roller, and the guards (2"x1/8" C channel) would only last a match or two before they folded in to the point they were touching the roller. Or are you just banking on most robots being short enough they come in under the roller and just bang against the frame?
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: KingKrab Frame isometric | AdamHeard | Extra Discussion | 3 | 07-12-2008 03:34 |
| pic: First Fully Functioning 1024 2008 Machine - Isometric View | Qbranch | Extra Discussion | 17 | 15-02-2008 16:56 |
| pic: Dawgma 1712 as of 1-15-07 | Chuck Glick | Extra Discussion | 14 | 03-02-2007 12:43 |
| pic: Isometric View of A 6WD module | Cody Carey | Extra Discussion | 8 | 04-01-2007 17:19 |
| Alice Goes Four Wheelin' (Autonomously) | Kevin Watson | General Forum | 26 | 16-10-2005 18:17 |