|
|
|
 Don't put sprockets in an empty pizza box and then throw it into the garbage. Something we learned from experience. - Herodotus [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Don't put sprockets in an empty pizza box and then throw it into the garbage. Something we learned from experience. - Herodotus [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
CRio Not Responding
Ok here is what is happening. Our CRio was responsive but now we can not get any code running. The battery voltage on the DS comes up as 00.00. I have no idea what happened. It is only a few days until shipment please help me!
|
|
#3
12-02-2009, 23:13
|
||||
|
||||
|
Re: CRio Not Responding
It loads but nothing happens.
|
|
#4
12-02-2009, 23:15
|
|||
|
|||
|
Re: CRio Not Responding
If you just push the run button on your robotMain, what happens?
Greg McKaskle
|
|
#5
12-02-2009, 23:20
|
||||
|
||||
|
Re: CRio Not Responding
The code deploys and our robot will not move all the lights blink and the voltage on the driver station says 00.00.
|
|
#6
12-02-2009, 23:29
|
||||
|
||||
|
Re: CRio Not Responding
We had this happen to us after labview crashed while uploading code. Reimage the cRio then reload your code. Thats what fixed it for us
|
|
#7
12-02-2009, 23:45
|
|||
|
|||
|
Re: CRio Not Responding
My suspicion is that you have a version problem between the cRIO and the WPI library.
If you launch the dashboard it will show errors occurring on the cRIO. I think it is -44085 that indicates a version problem. If this is your problem, reimage the cRIO to v11, and be sure to push the checkbox to reformat. Greg McKaskle
|
|
#8
13-02-2009, 08:12
|
||||
|
||||
|
Re: CRio Not Responding
We re-imaged it twice and nothing worked.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Speed controllers not responding | augzodia | National Instruments LabVIEW and Data Acquisition | 4 | 30-01-2009 01:20 |
| Motors not responding to joysticks | indubitably | FRC Control System | 6 | 08-01-2009 16:14 |
| Camera Not Responding To Code | itzrobz | Programming | 2 | 05-02-2006 12:47 |
| grab frame not responding | ahmed | LabView and Data Acquisition | 4 | 28-01-2006 10:49 |
| STAMP II not responding to computer | archiver | 2000 | 4 | 23-06-2002 22:24 |
Linear Mode
