Problem Getting Victors to run with the new control system

[Boommaster713]

i can see having having only one port not work correctly like chmp09 is saying but we have three victors on ports 5,6,7 and none of the three work properly

[Boommaster713]

we have had an extension of the same problem arise since we have replaced the victors with jarguars in that we cannot get any motors to run outside of the drive system when we combine the mechanism program and our drive program

[gburlison]

Originally Posted by Boommaster713

i can see having having only one port not work correctly like chmp09 is saying but we have three victors on ports 5,6,7 and none of the three work properly

Last night we noticed that when we had three Victors on one Sidecar we had problems, but when we moved one to the second sidecar all three worked fine. We also had four Jaguars on the first Sidecar. There might be some impedance/current issues with too many speed controllers on one Sidecar. This is just a guess at this point.

[Boommaster713]

For clarification, we changed out the problematic Victors with Jaguars, and are still having the same problem.

We can run the four drive jaguars using the start 4 motor command, or we can run our other three jaguars using the start motor command. However, if we try to do both, nothing works.

we also are only using a single digital sidecar with 7 jaguars plugged in to it

[chmp09]

Do the lights on the jags blink like they are disabled or are they solid?

Also, connect your computer to the cRIO when you run the cod. Does the open motor vi or the set motor give you an error? If so, try to trace it to the source.

[camper365]

What is happening is that you are sending the signal to the robot as a jaguar.
Under the open motor, you see a drop down menu, select Victor instead of Jaguar.

[chmp09]

Originally Posted by camper365

What is happening is that you are sending the signal to the robot as a jaguar.
Under the open motor, you see a drop down menu, select Victor instead of Jaguar.

I don't think that this will cause a problem because we have switched out victors for jags. Also, they said that they had replaced the jags with victors.

[T3H_K3YM45T3R]

My team is having to switch to victors because the jaguars we have failed. and our victors aren't doing anything but flashing. the code has been adjusted to run victors instead of jags and when it's enabled they flash as though there is no wire plugged in, the pwm cables are plugged in correctly, I've tried using several different slots on the DSC and get nothing... any help would be greatly appreaciated

[Cjdowney]

Make sure you're paying attention to the dates, this topic was made last year. We had a similar problem with v20.