|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
|
||||
|
||||
|
Re: pic: Team 2039 almost done
We haven't had any problems with ball handling. We squeeze the ball down to 7" diameter. The rollers are made of 2" ID pvc pipe (painted) with small grooves to hold the belts in. The pneumatic tubing spikes help hold the belts in place. We also have 7% length stretch on the belting. On the rear conveyor system we are also using pieces of the timing belt that came in the kit rivoted to the tube to help prevent the belts from sliding around. Hope this helps!
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: Team 48 Robot Almost Done | Travis Hoffman | Extra Discussion | 3 | 18-02-2008 10:24 |
| pic: Team 401 Overdrive -- Almost Done 1 | ggoldman | Extra Discussion | 2 | 10-02-2008 14:17 |
| pic: Team 56 Almost Done | jfischer | Robot Showcase | 12 | 18-02-2005 23:41 |
| Pic: Team 20 almost done | Ein | Robot Showcase | 2 | 16-02-2005 20:55 |