|
|
|
 The answer the last 3 years would be any regional that 1114 attends. - Cory [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating: 
|
Display Modes |
|
|
|
| The answer the last 3 years would be any regional that 1114 attends. - Cory [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating:
|
Display Modes |
|
#8
13-02-2009, 17:32
|
|||
|
|||
|
Re: Programming Double Solenoid?
Alright, we found out the programming wasn't the problem. Its something with the cRIO. In the programming we went to channel 7 and 5 and on the actual relay pins were on 6 and 4 and it magically works. We thought that then if we did 2 in the programming then it would be 1 on the relays and we tested it, thinking it was programming channel -1= relay and that doesn't work... We're completely clueless. Has this happened to anyone else and if it did is there a chart as to what is what?
Last edited by Brandon_L : 13-02-2009 at 17:40. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| double solenoid diodes? | ay2b | Pneumatics | 3 | 30-01-2008 16:50 |
| Double Solenoid Wiring | blindguyinanorg | Pneumatics | 7 | 09-10-2004 23:55 |
| Double Solenoid Wires | Lord Nerdlinger | Pneumatics | 4 | 17-02-2004 19:54 |
| double solenoid | gail | OCCRA | 0 | 11-10-2002 19:42 |
| Pneumatics: Double Solenoid | archiver | 2001 | 13 | 23-06-2002 23:57 |
Threaded Mode