|
|
|
 I'm so conflicted right now. On one hand, you made the same page as a celebrity. On the other hand.... Justin Bieber. - Akash Rastogi [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I'm so conflicted right now. On one hand, you made the same page as a celebrity. On the other hand.... Justin Bieber. - Akash Rastogi [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#9
13-02-2009, 22:38
|
|||
|
|||
|
Re: 80 millivolt sensor on breakout?
Okay, I'll try oversampling. The signal is from a motor, so there may be too much noise. I'll see if it works. Hopefully it does, as we have almost no other option. Also, what rate should I use (I will be sampling one ADC on each analog breakout) to get the best resolution? I'm confused, as there are several numbers and I want to know which to use. Is 62K as Russ Beavis says the fastest sampling you can get if you only need one signal, or can we go faster if we aren't using all the signals? Thank you.
Last edited by skidmarks : 13-02-2009 at 23:27. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wiring a potentiometer to the Analog Breakout | rsisk | Electrical | 6 | 19-01-2009 12:49 |
| Analog Breakout for sale? | DarKCroNo | FRC Control System | 1 | 05-01-2009 16:39 |
| Wiring analog breakout? | excel2474 | Electrical | 5 | 31-12-2008 17:30 |
| Pneumatic breakout question. | IndySam | FRC Control System | 5 | 23-12-2008 17:10 |
| 5 Amp Fuses for Analog Breakout & Solenoid Breakout | finman | Electrical | 3 | 10-12-2008 11:59 |
Threaded Mode