|
|
|
 Holy Underwriters Laboratories Industrial Safety Awards Batman! - AndyB [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Holy Underwriters Laboratories Industrial Safety Awards Batman! - AndyB [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Autonomous Issue
Hi,
so.. I have some problems with the autonomous...it just won't work, I'm using the advenced frimwork on LabVIEW, and I'm also using Iterative autonomous mode (or something). I'm trying to make the motors get a diffrent value every 3 secends...but when I put a sleep function of 3 secends and a while loop, the motors move for a moment and then they stop for 3 secends... what can I do?? Ori-2630 
|
|
#3
14-02-2009, 19:38
|
|||
|
|||
|
Re: Autonomous Issue
If the watchdog is opened, then it needs to be fed during the three seconds. To do this there is a VI in the palettes called Delay and Feed. Use it instead of the plain delay. The other option is to set the timeout on the watchdog bigger than your delay, or to disable it.
Greg McKaskle
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Debugging issue | dpeterson3 | C/C++ | 3 | 11-02-2009 20:11 |
| Lag Issue | bizarospooky | Programming | 7 | 08-02-2008 17:31 |
| decoder issue | TEAM1949 | Programming | 10 | 07-03-2006 14:34 |
| printf issue | Max Brin | Programming | 6 | 24-01-2006 17:03 |
| Autonomous issue NJ | M. Hicken | Programming | 2 | 16-02-2005 21:59 |
Linear Mode
