|
|
|
 This is an open forum and it is a privilege to post here, if you don't agree with the rules then just don't post here. - dez250 [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| This is an open forum and it is a privilege to post here, if you don't agree with the rules then just don't post here. - dez250 [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Robot doesn't respond when i add a fifth motor
I programmed 4 CIM motors using jags and i tried adding another motor(Not CIM) to a victor and my robot becomes unresponsive. The code works just fine. I probe the wires and i recieve a value so i know the code works but the robot doesn't respond at all. If i take the fifth motor out of my code the robot works again. Does anyone know why this happens?
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| When a robot doesn't show up ... | GaryVoshol | General Forum | 3 | 13-02-2009 10:49 |
| Program doesn't effect robot | travmizer | Programming | 8 | 23-01-2008 10:52 |
| pic: When One BaneBots Doesn't Do | team222badbrad | Robot Showcase | 7 | 07-03-2006 10:20 |
| Robot doesn't drive straight | bush | Control System | 14 | 09-02-2006 00:00 |
| Robot reset on OI doesn't work | Carl Owenby | General Forum | 1 | 07-02-2003 07:23 |
Threaded Mode