|
|
|
 Don’t choose to aim for the stars because they mark the peak of our abilities, don’t choose to aim for the stars because it is easy, choose to aim for the stars because it shows the depth of our potential; choose to aim for the stars because it is hard! - Ken Leung [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Micro Switch + PWM = Button?
I have put together a "joystick" or a "button" by soldering a PWM to a micro switch(from the KOP). However, we cannot get the robot to read the button input. We do not believe the code is wrong (It might be wrong) and I'm wondering if its just the way the micro switch is connected to the Driver Station. I did a continuity test and it does have current flowing through it when the switch (button) is pressed. Is it possible to use the micro switch as a button for shooting? Is using a PWM the problem? Please reply ASAP
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Micro Switch Code | dboisvert | C/C++ | 2 | 13-02-2009 13:34 |
| button Switch | GunfighterJ | Programming | 10 | 10-02-2009 19:39 |
| using a switch/button to turn on a motor | smcmahon | NI LabVIEW | 3 | 26-01-2009 18:42 |
| push-button switch on robot | Conan | Electrical | 4 | 10-02-2006 22:03 |
| Need Help Wiring Micro Switch/Limiting Switch | Windward | Electrical | 2 | 07-02-2006 18:26 |
Threaded Mode