|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
Re: CIM Legality
<R52> prohibits motors other than those in the kit and those specified in <R51>D. The bolded text from <R51> specifies the 2 1/2" CIMs and part numbers, so any CIMs you use other than the two provided in the kit must be the same 2 1/2" size/design motor.
|
|
#2
|
|||
|
|||
|
Re: CIM Legality
Rule 51 D says 4 and no more 2 1/2" CIM motors. What about Cims of other sizes?
Curious because it doesn't say '4 CIM motors total- of any size'. |
|
#3
|
|||
|
|||
|
Re: CIM Legality
The rule boils down to this: you may use a grand total of 4 Cim motors identical to the ones in the kit. You may not use the larger 3" Cims that have been provided in previous years.
|
|
#4
|
|||||
|
|||||
|
Re: CIM Legality
Quote:
Quote:
|
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| witricity legality? | XXShadowXX | Electrical | 68 | 10-05-2008 07:58 |
| NJ Regional: IR Legality | LH Machinist | Control System | 17 | 29-02-2008 06:27 |
| Legality question | SonicKidGJ | VEX | 6 | 13-01-2008 14:00 |
| your thoughts on the FP CIM/2.5 CIM motor drive setup versus 2 2.5 CIM motors | waialua359 | Motors | 11 | 14-12-2007 04:29 |
| legality question | rbayer | General Forum | 8 | 15-09-2002 00:25 |