joystick axis in labview

frcchile · #1 15-02-2009, 17:54

Hello, I want to know how is the axis in joystick, because i want programing one motor that jostick when I move up, the motor moves forward,I move down, the motor moves back

And, how is the axis in jostick?

Thank you

Greg McKaskle · #2 15-02-2009, 18:54

You want to use the Joystick Get or Get Axis. I think Axis 2 is the Y. It returns -1 to 1 range, -1 forward and 1 backwards.

Outside the loop do a joystick open and close on the left and right.

Greg McKaskle

frcchile · #3 15-02-2009, 19:00

Quote:

Originally Posted by Greg McKaskle

You want to use the Joystick Get or Get Axis. I think Axis 2 is the Y. It returns -1 to 1 range, -1 forward and 1 backwards.

Outside the loop do a joystick open and close on the left and right.

Greg McKaskle

I want programing in Labview... what icon work? why in labview I see 6 axis? i dont understand

Thank you

dani190 · #4 15-02-2009, 19:01

Quote:

Originally Posted by frcchile

I want programing in Labview... what icon work? why in labview I see 6 axis? i dont understand

Thank you

choose axis 3...

The other axis, are nothing to worry about...

Tt321b · #5 15-02-2009, 19:13

Actually axis 1 (x) is right/left, axis 2 (y) is up/down and axis 3 is the throttle on the bottom front of the joystick. The other axis don't exist on this joystick but other joysticks can have them.

dani190 · #6 15-02-2009, 19:14

Quote:

Originally Posted by Tt321b

Actually axis 1 (x) is right/left, axis 2 (y) is up/down and axis 3 is the throttle on the bottom front of the joystick. The other axis don't exist on this joystick but other joysticks can have them.

isnt that what i just said

frcchile · #7 15-02-2009, 19:34

Quote:

Originally Posted by Tt321b

Actually axis 1 (x) is right/left, axis 2 (y) is up/down and axis 3 is the throttle on the bottom front of the joystick. The other axis don't exist on this joystick but other joysticks can have them.

I can move one motor with up/down, in the program is open motor jaguar-with josystick get and axis Y - motor set speed

Is the correct program for move one motor with only Axis Y

Thank you!!!!

smackee618 · #8 20-02-2009, 12:06

Quote:

Originally Posted by dani190

isnt that what i just said

Not quite.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Axis 3 on joystick	camper365	Programming	3	13-02-2009 22:49
labview:what is the joystick axis?	mcristina444	NI LabVIEW	4	08-02-2009 13:26
pwm outputs vs. joystick y-axis	stephenthe1	Programming	4	01-12-2004 17:29
Inverting Y axis on joystick	FormatteD_C	Programming	7	24-02-2004 16:56
switching joystick axis?????	team222badbrad	Technical Discussion	9	16-01-2002 23:07