|
|
|
 Glue it, screw it, bolt it, rivet it, weld it. If the design is flawed it will fail. - Gdeaver [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Glue it, screw it, bolt it, rivet it, weld it. If the design is flawed it will fail. - Gdeaver [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
programing motor with axis
Hi, I want programing one motor only move with joystick up/down, my question is for conecting motor with axis, is open motor jaguar with get speed and get speed conecting to joystick get and in joystick get is axis (X) only for up/down...
  Thank you |
|
#2
16-02-2009, 08:30
|
|||||
|
|||||
|
Re: programing motor with axis
Axis 1 is the X axis, moving left/right.
Axis 2 is the Y axis, moving forward/back. Axis 3 is the Z "throttle" axis. |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Programing with camera? | excel2474 | Programming | 3 | 14-02-2009 08:08 |
| Can any one help us with programing the encoder to control the motor by ticks? | Must Be Drama | NI LabVIEW | 4 | 09-02-2009 20:54 |
| Programing servo in Axis camera 206 | frcchile | NI LabVIEW | 6 | 18-01-2009 08:53 |
| Problems with the Axis Camera | popo308 | FRC Control System | 16 | 15-01-2009 19:38 |
| help with programing banner senor. | incognito_NICK | Programming | 2 | 17-11-2004 06:51 |
Linear Mode
