How to set the deadband in motor vi

My teams robots have been good, bad and ugly BUT they were all beautiful because they were there. - JohnBoucher [more]

		Chief Delphi > Technical > Programming > NI LabVIEW
How to set the deadband in motor vi

Thread Tools

Rate Thread

Display Modes

16-02-2009, 11:57

RickErmer

Registered User

FRC #0073

Join Date: Feb 2007

Location: Rochester, Ny

Posts: 3

RickErmer is an unknown quantity at this point

How to set the deadband in motor vi

How do you set the deadband in motor vi? I would actually like to set a non-symmetric deadband, but can't figure out how to set one at all.

Thanks,
Rick
Team 73

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Labview servo motor PWM correlation to set VI	mbone206	NI LabVIEW	4	30-01-2009 14:58
How to end an auto mode after gyro gets out of deadband	kiettyyyy	Programming	17	20-04-2006 07:59
How to set up and run a FF League properly.	Alex Cormier	Fantasy FIRST	4	27-02-2006 17:18
Running a motor for a set time in auton	Morgoth	Programming	5	11-03-2003 13:59
How do you set a speed limit on the servo	Fares	Programming	6	01-01-2003 15:04

All times are GMT -5. The time now is 10:42.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.