Pneumatics Programing

[Mark McLeod]

You can leave out the timer from the example. Just take the solenoid, etc. vi's. It should run at the same rate as your other joystick based functions.
That was just a stand-alone sample of a basic loop.

[star_lancer]

Originally Posted by Mark McLeod

You want the solenoid check inside your teleop loop, since that's where you are reacting to joystick commands.

The compressor you want operating in both autonomous and teleop modes so that goes elsewhere.
Really, the compressor Open and Start should be in the Begin.vi and the Close in Finish.vi. You need to add the compressor cluster information to RobotData.ctl so it can be used in the Finish.vi

P.S. I'm assuming by what you said that you're using the Advanced Framework. If you're using the Basic one instead it's a little different.

Can I get an image on how this is done? I don't know what you mean by begin.vi or finish.vi