|
|
|
 I'm not worried about talking to the robot, but I am worried about when the robot starts talking back... - Moros [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I'm not worried about talking to the robot, but I am worried about when the robot starts talking back... - Moros [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
Re: Voltage doesn't display
You must have the analog input in the cRIO, and you must
put the little jumper on that connects the battery voltage to analog input 8. Not only is it a good idea, it is required by the rules. See page 22 of the Control System Component Datasheets Eugene 
|
|
#2
16-02-2009, 23:25
|
||||
|
||||
|
Re: Voltage doesn't display
The jumper is on the analog breakout board, which should be installed on the analog module in slot 1. Also make sure there is power to the analog breakout board. It should be connected to a 12 volt outlet of the power distribution board and make sure it has a breaker and that the wires to the PD board are inserted properly.
Brian
|
|
#3
17-02-2009, 00:14
|
|||
|
|||
|
Re: Voltage doesn't display
Our team followed the explicit rules yet ours shows 0.00 as well. Anyone know the reasoning for this?
And yes, all directions were followed and triple checked by our elec engineer as well.
|
|
#4
17-02-2009, 00:28
|
|||||
|
|||||
|
Re: Voltage doesn't display
Quote:
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| OI Display problem? | Shu Song | Control System | 4 | 01-02-2005 20:42 |
| OI Display problem? | Shu Song | Electrical | 4 | 01-02-2005 20:42 |
| OI Voltage | JAH | Electrical | 7 | 12-11-2004 20:01 |
| Voltage Byte -> True Voltage | Ulibrium | Technical Discussion | 11 | 01-03-2002 08:55 |
| LCD display | James Crivellone | Rules/Strategy | 6 | 06-01-2002 10:22 |
Hybrid Mode
