|
|
|
 I saw a big opening in the bees section and asked if we could sit for this match and was told we were welcome to sit there. Your team made space for about 15 of my team members that came with me. - Debbie [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
Re: Using a pot to control speed
Are you reading the pot inside the loop? It sounds like you are reading it once outside the loop and then acting forever on that one value.
Greg McKaskle 
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Speed control | Drake Hunter | Programming | 1 | 11-02-2009 23:08 |
| can we control the amount of air to control the speed of the cylinder? | Team2339 | Pneumatics | 22 | 11-02-2009 15:33 |
| Labview questions, using motor and pot as a servo | martin417 | NI LabVIEW | 7 | 05-02-2009 16:43 |
| Drive Control, Wheel Speed Calibration, and Rapid Speed Changes | 7-11number1 | Programming | 3 | 23-01-2008 20:36 |
| are we allowed to control a window motor using a speed controller? | Wstedtlogan | Motors | 1 | 19-02-2006 15:47 |
Hybrid Mode
