|
|
|
 I always mean what I say. I just don't always say what I mean. - dlavery [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| I always mean what I say. I just don't always say what I mean. - dlavery [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
cRio resetting itself, too low voltage?
We are having a problem. As we are testing all of the systems in our robot, the cRio will randomly stop, and then come back on twenty seconds or so later like when we reset it.
Watching the voltage indicator on the DS it appears as if this happens around 11.5V ... is that right? Is there a setting wrong somewhere? Any ideas? 
|
|
#2
16-02-2009, 16:21
|
|||
|
|||
|
Re: cRio resetting itself, too low voltage?
This behaviour usually happens when you plug the cRIO into something other than its dedicated 24V supply. Can you post a picture of your wiring?
|
|
#3
16-02-2009, 17:12
|
|||
|
|||
|
Re: cRio resetting itself, too low voltage?
Are you loading the battery, e.g. running the motors and slamming them into reverse? Depending on your battery you could see a droop which would cause the 24V to drop and reset the controller.
|
|
#4
16-02-2009, 20:34
|
||||
|
||||
|
Re: cRio resetting itself, too low voltage?
It was plugged into 24V. It may have been low/bad battery. Just wanted to be sure this was not a usually situation.
|
|
#5
16-02-2009, 20:35
|
|||
|
|||
|
Re: cRio resetting itself, too low voltage?
Not usual at all - in fact I would classify it as "something is wrong", most likely with the power supply / battery.
|
|
#6
16-02-2009, 20:41
|
|||
|
|||
|
Re: cRio resetting itself, too low voltage?
There are some bad batteries floating around from 2008. They will give good open circuit voltage and then die horribly under a load.
To my knowledge we haven't had a broken 24V supply yet, but this doesn't mean that it couldn't happen. If it isn't the battery, we may need to look deeper.
|
|
#7
17-02-2009, 09:22
|
||||
|
||||
|
Re: cRio resetting itself, too low voltage?
We were using the 2008 battery, trying to save competition batteries.
So most likley that is what it was. Thanks for the assurance.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| cRIO low execution rate | Anne_droid | C/C++ | 1 | 15-02-2009 17:38 |
| Gyro resetting and recalling? | Tom Line | Programming | 1 | 17-02-2008 09:05 |
| ADXRS150 default voltage is too low.. | hinewwiner | Technical Discussion | 1 | 10-02-2008 05:12 |
| Bug: Login Problems - Session timeout value too low? | DanL | CD Forum Support | 4 | 09-01-2004 16:33 |
| Computer resetting? | David Kelly | Chit-Chat | 0 | 12-08-2003 17:21 |
Linear Mode
