|
|
|
 And we had to walk both ways to the venue from our hotel! Uphill! Barefoot over broken glass! - IMDWalrus [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| And we had to walk both ways to the venue from our hotel! Uphill! Barefoot over broken glass! - IMDWalrus [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Encoders not working
I am using the quadrature encoders that were included in the kit. I am experiencing an odd problem where the signal suddenly drops out soon after we start driving. I have attached a graph of the signal (after a low-pass filter) that shows the dropout very clearly. Here are some possible causes that have occurred to me
(1) The signal, which is passed through two solder joints and then a DB-25 connector, is somehow degraded to an unusable point. (2) The camera processing is interfering with the encoder counting. (CPU usage is in the 80-90% range.) (3) Something else? Which of these is most likely? Any help will be most appreciated. David Team 1751 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| jaguar not working | Bwood16 | Motors | 12 | 13-02-2009 13:22 |
| cRio not working...? | Jack Gillespie | Programming | 22 | 13-02-2009 13:07 |
| p2 not working? | Lone_Wolf92c | Programming | 5 | 22-02-2008 08:49 |
| IR Board Not Working (But NOT Fried) | itsme | Electrical | 2 | 18-02-2008 06:11 |
| Encoders not changing... | paulcd2000 | Programming | 28 | 18-02-2007 08:34 |
Threaded Mode