pic: Main Breaker Opened

gburlison · #1 18-02-2009, 09:21

Mike Soukup · #2 18-02-2009, 09:23

The same thing happened to us. We put the new breaker on our prototype robot this year and it was sticky from the start. It failed just like yours did last week. It looks like some of us got a bad batch this year.

MrForbes · #3 18-02-2009, 10:16

Come on, open it up the rest of the way! pull the rubber gasket off, let's see what's inside! There's probably something not right that is causing the shaft to be hard to turn. Lack of lubricant? parts not made to size?

Matt C · #4 18-02-2009, 11:54

We had a switch fail on us too. We grabbed one off of an old robot to replace it. (These switches are available from marine supply stores like West Marine FYI, or at least the one near me carries them.)

MrForbes · #5 18-02-2009, 11:55

We put the new breaker on the robot right before shipping it, so I guess we better bring along the previous year breaker that we used for all our build season testing.

Thanks for letting us know about the problems!

SuperBK · #6 18-02-2009, 12:19

I have noticed ours is rather stiff to turn on too. Good idea about the spare.
Brian

RyanN · #7 18-02-2009, 13:07

I've seen the breakers at AutoZone as well.

MrForbes · #8 18-02-2009, 13:14

Very similar breakers are sold many places, but many of them don't have the "on" switch....they only have a reset button. Be careful what you buy.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
pic: This opened our Graduation.	bigbeezy	Extra Discussion	5	04-06-2008 00:01
2006 FRC Registration Opened	master	General Forum	12	07-09-2005 14:46
Main Circuit Breaker	Yan Wang	Electrical	6	20-02-2003 10:23
Main on/off breaker	Brett W	Technical Discussion	4	07-01-2003 23:35
New Forum opened up.	archiver	2000	1	23-06-2002 22:22