|
|
|
 Of course, someone who can score on all rack levels while hovering autononmously 12 inches off the floor in his own home zone could probably have posted on CD while winning a regional.;) - Richard Wallace [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#7
19-02-2009, 08:14
|
|||||
|
|||||
|
Re: axis camera power cable falling out..
Double check that the center pin is not bent. Both conditions you describe relate to the center pin not being in position enough to provide good contact with the center contact of the power cable. Double check that the center pin is in the camera and not broken off inside the power cable.
Last edited by Al Skierkiewicz : 19-02-2009 at 23:22. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need help with Axis 206 Power Adapter | dipmeinaluminum | FRC Control System | 1 | 21-01-2009 20:01 |
| Can't figure out the Axis camera setup... | 2829ron | Technical Discussion | 6 | 20-01-2009 13:12 |
| 2007 Controller Power cable? | reflion | Electrical | 7 | 16-01-2009 07:33 |
| AXIS Camera | nickmagus | Programming | 1 | 03-01-2009 20:06 |
| Camera power cable | MustangRobotics | General Forum | 11 | 12-01-2006 22:39 |
Threaded Mode