Imported Geometry?

Ryan M · #1 19-02-2009, 22:34

Is there an easy way to tell if geometry has been imported from software other than Inventor? If not, is there any KoP or firstcadlibrary.com models that would result in a point deduction for the Autodesk Design Competition?

Jeff 801 · #2 19-02-2009, 22:49

yes if on the part under the model panel there is a base 1 listed that means there is one that is what the imported part of the model will be called for example the jag that you get from firstbase is imported and then they added some extrusions to it so it looks right.

JD Mather · #3 20-02-2009, 11:29

If you use imported geometry you could use the free Feature Recognition from http:\\labs.autodesk.com to rebuild a feature history tree.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
ing a texture via geometry.	adamrw91	3D Animation and Competition	4	16-01-2008 10:45
Taxicab Geometry	Astronouth7303	Math and Science	23	15-05-2004 23:27
Map Coordinates on imported objects	Jacob Reif	3D Animation and Competition	2	04-02-2003 01:27