|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools | Rate Thread | Display Modes |
|
#16
|
||||
|
||||
|
Re: Reducing globe motor without special tools.
I meant 400 to 500 rpms, I think I heard around 486 somewhere? For me, that rpm range is good enough to design with. Good luck.
![]() -Vivek |
|
#17
|
|||||
|
|||||
|
Re: Reducing globe motor without special tools.
you don't even need a special spacer, last year 612 just used a bunch of washers. Motors held up for 2 regionals, championship, couple off seasons, and are still going.
|
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Globe Motor | RMS11 | Motors | 7 | 01-07-2008 20:36 |
| globe motor | lil_longo | Motors | 1 | 18-02-2006 12:27 |
| globe motor | chrisinmd | Motors | 9 | 11-02-2006 10:58 |
| Globe Motor | Team168 | Programming | 3 | 16-02-2003 11:50 |
| Globe Motor | archiver | 2000 | 4 | 24-06-2002 00:15 |