autonomous mode help please...

Mark McLeod · #1 20-02-2009, 22:36

Quote:

Originally Posted by tomy

sorry for all the questions but on the motor control for my manipulator shouldn't i have a joystick close...?

Yes, you're right. It does need a joystick Close too.

Quote:

Originally Posted by tomy

okay i am just hopping that you guys are right and that this will drive just like when i had it before

The last programmer I showed this to didn't remember that the PWM order feeding the Open 4 Motor vi mattered. No promises, but if you have trouble just ask at your Regional for a LabVIEW programmer to take a look.

tomy · #2 20-02-2009, 22:48

so then is this right

Mark McLeod · #3 20-02-2009, 23:00

Looks good.

P.S.
Change Arcade Drive to Tank Drive in "TeleOp Reset" too.

tomy · #4 20-02-2009, 23:11

how sure are u that it will work, all of it jusst like i had it before

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Autonomous mode help	Drake Hunter	NI LabVIEW	3	12-02-2009 01:52
Help needed in autonomous programming for hybrid mode	Team_STORM	Programming	3	21-01-2008 19:11
Autonomous Mode HELP!	jesusescobar	Programming	4	12-02-2007 12:02
Help - Making the autonomous mode	razer	Programming	5	31-01-2007 16:25
Simulating autonomous mode - i need help!! :(	itay_ms	Programming	5	21-01-2007 11:28