|
|
|
 We found our bandsaw on Craigslist for $40. We keep looking for laser cutters and waterjets in that price range, but so far no luck. - chapman1 [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| We found our bandsaw on Craigslist for $40. We keep looking for laser cutters and waterjets in that price range, but so far no luck. - chapman1 [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#6
24-02-2009, 11:54
|
||||||
|
||||||
|
Re: CIM Hub
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Sprocket with hub or without? | Vikesrock | Technical Discussion | 5 | 15-01-2008 01:14 |
| your thoughts on the FP CIM/2.5 CIM motor drive setup versus 2 2.5 CIM motors | waialua359 | Motors | 11 | 14-12-2007 04:29 |
| Hub for Wheel attachments | Lavapicker | Kit & Additional Hardware | 5 | 09-01-2007 19:27 |
| Re: Connecting hub sprockets to shafts | archiver | 2001 | 1 | 24-06-2002 00:20 |
| Connecting hub sprockets to shafts | archiver | 2001 | 18 | 24-06-2002 00:04 |
Threaded Mode