CIM Hub - Chief Delphi

They can either incorporate the suggestions in this thread, go totally against them, or even make us all write code on banana peels with our fingernails. - Andy Baker [more]

		Chief Delphi > Technical > Kit & Additional Hardware
CIM Hub

Thread Tools

Rate Thread

Display Modes

24-02-2009, 13:28

Uberbots

Mad Programmer

AKA: Billy Sisson

FRC #1124 (ÜberBots)

Team Role: College Student

Join Date: Jan 2006

Rookie Year: 2005

Location: Avon

Posts: 739

Re: CIM Hub

Quote:

Originally Posted by Brandon Holley

Of all the lessons I've learned in FIRST...the one I've learned the hardest is never trust a set screw...

QFT

our 2007 arm joint had a sprocket attached by a set screw on the motor output shaft... needless to say we had a lot of slipping that year.

__________________

A few of my favorite numbers:
175 176 177 195 230 558 716 1024 1071 1592 1784 1816
RPI 2012
BREAKAWAY

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Sprocket with hub or without?	Vikesrock	Technical Discussion	5	15-01-2008 01:14
your thoughts on the FP CIM/2.5 CIM motor drive setup versus 2 2.5 CIM motors	waialua359	Motors	11	14-12-2007 04:29
Hub for Wheel attachments	Lavapicker	Kit & Additional Hardware	5	09-01-2007 19:27
Re: Connecting hub sprockets to shafts	archiver	2001	1	24-06-2002 00:20
Connecting hub sprockets to shafts	archiver	2001	18	24-06-2002 00:04

All times are GMT -5. The time now is 06:51.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.