|
|
|
 If your robot can't play at least two matches on one battery, your mechanical design and/or driver strategy needs some rethinking. - Al Skierkiewicz [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| If your robot can't play at least two matches on one battery, your mechanical design and/or driver strategy needs some rethinking. - Al Skierkiewicz [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#9
24-02-2009, 15:27
|
||||
|
||||
|
Re: CIM Hub
The set screw does fall into the keyway slot and has shaft collars on either side.
As long as we can keep it the screw tight, we should be ok. We don't have the machining capabilities to broach a hole in a timing belt pulley. -Vivek |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Sprocket with hub or without? | Vikesrock | Technical Discussion | 5 | 15-01-2008 01:14 |
| your thoughts on the FP CIM/2.5 CIM motor drive setup versus 2 2.5 CIM motors | waialua359 | Motors | 11 | 14-12-2007 04:29 |
| Hub for Wheel attachments | Lavapicker | Kit & Additional Hardware | 5 | 09-01-2007 19:27 |
| Re: Connecting hub sprockets to shafts | archiver | 2001 | 1 | 24-06-2002 00:20 |
| Connecting hub sprockets to shafts | archiver | 2001 | 18 | 24-06-2002 00:04 |
Threaded Mode