|
|
|
 So go out and learn something new, even if it is old. Co-operate in this and you'll get much more out of it. Cheat and you are only cheating yourself. - ChrisH [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| So go out and learn something new, even if it is old. Co-operate in this and you'll get much more out of it. Cheat and you are only cheating yourself. - ChrisH [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Get Camera.vi slowdowns
When I run my camera processing code under a test harness, the get camera.vi runs at around 12-25 ms. However, once I move it into the main code, it starts to run at around 70-100 ms (checked by placing get camera.vi inside a flat sequence, and measuring tick counts before and after its execution). I haven't changed any camera settings, so that factor's out of the question. And the vision processing vis in both my test harness and main code are identical, only the main code incorporates all our other autonomous, teleop, and dashboard code. What could possibly be slowing get camera.vi down?
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Still can't get the camera to track | Jill | NI LabVIEW | 6 | 15-02-2009 16:31 |
| Adjusting Camera Code to get Better Image | Robopanda6 | NI LabVIEW | 1 | 31-01-2009 18:55 |
| Camera - how to get out of B&W? | pgaston | Technical Discussion | 9 | 19-12-2008 09:00 |
| first year team - cant get camera programmed | sniggel | Programming | 12 | 20-01-2007 02:20 |
| For anyone who doesn't get the camera code..... | Jake M | Programming | 8 | 16-01-2006 18:56 |
Threaded Mode