|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#7
|
|||
|
|||
|
Re: I can't build or deploy! Error 6?
I think I found the correct filepath. I made the change tried to build and got a lot of file collision warnings. I know from reading other threads that seems to be normal..right? At the end of the build it did say the build was complete.
Now, of course the robot shipped so I can't make sure it will deploy..but..when we get access to our robot again we will need to right click on "FRC Basic Robot Deploy Properties" then chose "run as startup"...right? |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Run works but build&deploy doesn't | program1 | NI LabVIEW | 3 | 03-02-2009 22:32 |
| LabVIEW Woes: Build/Deploy time too long?! | leftylink | NI LabVIEW | 7 | 27-01-2009 21:52 |
| Can't Deploy All of Project to cRIO | MachineSMMC | NI LabVIEW | 2 | 15-01-2009 18:41 |
| Build Error S.O.S. | TimeOut | Programming | 2 | 10-02-2006 00:10 |
| Build Error | Chris.Steimel | Programming | 13 | 26-01-2005 17:44 |