|
|
|
 If you can't be bothered to read the Q&A, why are you spending thousands of dollars competing? - Ian Curtis [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| If you can't be bothered to read the Q&A, why are you spending thousands of dollars competing? - Ian Curtis [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
01-03-2009, 21:34
|
|||
|
|||
|
Re: Autonomous selection from dashboard
While 1675 was messing around with more autonomous routines at Midwest this weekend, we found out that (at least the way we were doing it) when you try to read the digital IO pins in autonomous, it takes them from the state they were at driver station boot.
If you go this route, make sure you thoroughly test your system and that drivers know of any special procedures they need to follow to choose the mode they want. (We ended up not putting it in yet because we only used one autonomous routine.) |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Switching to/from autonomous mode | RDD | Programming | 6 | 12-02-2007 16:14 |
| Setting Autonomous Settings from OI | Tom Saxton | Programming | 15 | 27-03-2005 11:45 |
| Setting Autonomous Settings from OI | Tom Saxton | Control System | 4 | 14-03-2005 22:33 |
| Weird Output from Dashboard Port | Ian W. | Programming | 9 | 06-03-2004 21:33 |
| Autonomous Code From Experience | EbonySeraphim | Programming | 7 | 14-03-2003 21:56 |
Threaded Mode