pic: Team 2826 Robot

[Tyler Olds]

(Figured out how to add a description lol)

[Dan2081]

Hey looks great. You guys are rookies this year? You should do really well!

[Akash Rastogi]

I can almost guarantee this robot will do very well. Hopefully you've built this proven system well enough to perform like the proven robots from week 1. Best of luck and awesome job as rookies and for any team for that matter!

[R.C.]

Feel another 2753 type Win

[billbo911]

Where did you find those couplers for your square tube? Are those Home Brewed??
(Sorry, just had to throw in a WI. joke)

[camtunkpa]

Good looking bot 2826! Impressive swerve drive! Your team should do well!

Originally Posted by billbo911

Where did you find those couplers for your square tube? Are those Home Brewed??
(Sorry, just had to throw in a WI. joke)

I'm not 100% sure and ask 2826 to confirm, but they look like 80/20 quickframe connectors.

[EricLeifermann]

How are you going to actually hold the ECs? If they just sit in the yellow tubes, I'm afraid they will fall out before you have a chance to get them to the HP.

[Vikesrock]

Originally Posted by EricLeifermann

How are you going to actually hold the ECs? If they just sit in the yellow tubes, I'm afraid they will fall out before you have a chance to get them to the HP.

Looks to me like the PVC arms on each side are servo powered gates for the EC holder. The EC is placed in from the side with the arm down. When the robot reaches the airlock, the arm is raised and the EC rolls out the front.

[EricLeifermann]

Originally Posted by Vikesrock

Looks to me like the PVC arms on each side are servo powered gates for the EC holder. The EC is placed in from the side with the arm down. When the robot reaches the airlock, the arm is raised and the EC rolls out the front.

didn't read your post right.....

[EricLeifermann]

if you are planning on receiving the EC from the side i suggest not doing it that way, it gets you right up against the wall and that will make you SO easy to pin...

[Tyler Olds]

Originally Posted by camtunkpa

Good looking bot 2826! Impressive swerve drive! Your team should do well!



I'm not 100% sure and ask 2826 to confirm, but they look like 80/20 quickframe connectors.

Thanks for the compliments, it was quite a hill to climb and it involved a couple late nighters. Yes those are 80/20 quickframe connectors.

Originally Posted by Vikesrock

Looks to me like the PVC arms on each side are servo powered gates for the EC holder. The EC is placed in from the side with the arm down. When the robot reaches the airlock, the arm is raised and the EC rolls out the front.

You got it!

Like I said as well, our side paneling is not on so thats why it might seem like the EC would fall out.