Intresting Autonomous

[Vikesrock]

Originally Posted by Hazmatt

Ideally we would have had a "field position switch" which would allow us 3 different autonomous modes, but unfortunately a firmware update disabled this ability for us. Also unfortunate was that we already had the control panel made with the switch mounted.

Switches on the DS side can still be read and used to select Autonomous modes. The difference is that they now cannot be read in Autonomous/Enabled mode. Read them in Autonomous/Disabled and cache the values for use during Autonomous/Enabled. Also, there are reports that the values return incorrectly from the last cycle of Autonomous Disables, so make sure your code has a way of dealing with this.