|
Re: Forward/Reverse difference in drill motors.
Posted by Tim Gates at 03/21/2001 7:01 PM EST
Engineer on team #288, RoboDawgs, from Grandville High School and X-Rite/Delphi.
In Reply to: Forward/Reverse difference in drill motors.
Posted by Joe on 03/20/2001 7:22 PM EST:
Download an array into memory that represents the offset values and then READ P1_y,P1_y in your codef will substitute the off set on the fly.
Tim Gates
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.
|