|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating:
|
Display Modes |
|
#3
|
|||||
|
|||||
|
Re: [FTC]: Using two Hitechnic Motor Controllers in LabView
That's a point worth highlighting...
To control a third "independent" motor, you need a second motor controller. Phil. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [FTC]: OUT OF MOTOR CONTROLLERS?!?!?!? | ttldomination | FIRST Tech Challenge | 6 | 09-02-2009 18:48 |
| [FTC]: Labview can't use two controllers | dman14 | FIRST Tech Challenge | 8 | 04-02-2009 21:09 |
| [FTC]: Tips page on using FTC Encoders with LabVIEW | PhilBot | FIRST Tech Challenge | 7 | 27-01-2009 14:00 |
| [FTC]: Problem with two controller setup in Labview | wilsonmw04 | FIRST Tech Challenge | 2 | 11-11-2008 19:58 |
| [FTC]: FTC Servo-Motor Problem with Labview | dnhansen | FIRST Tech Challenge | 1 | 26-10-2008 00:43 |